Monday 24 August 2009

Sorted.

One transfer box.

I spent most of saturday changing the transfer box for one that wasn't quite so knackered.

From the 1/4" of swarf like silt that was on the bottom of the cover plate, I'd say it wasn't before time either. The wear on the intermeadiate shaft teeth was pretty impressive, as was the amount of free play in the output shaft bearings.

It was really a fairly painless job - I didn't even need to pull the seatbox, as I split the box in situ, and then droped the transfer box/front output shafts out underneath. (Disclaimer if anyone else trys this - I don't know if there is enough room or not on an 88")

Its quite nice being able to hear the engine again for a change.

I've collected an overdrive that looks to have nothing much wrong with it apart from missing some selector pads, but it didn't have an imput clutch assembly(the bit that is bolted to the mainshaft). Murphy's Law states that this means the bearing on my old imput clutch had gone, so I'll have to get a new one from Craddocks. The good news is that they are avalable, for a mere £23 + vat + post...

Still, I miss having the overdrive - when I went to collect the spare one yesterday, I found I kept looking for the overdrive lever to change up, particularly on the motorway. Having to keep down to about 65mph is painful once you know what motorways are like with an overdrive and a 200...

1 comment:

estwdjhn said...

I got this emailed me...cheers Nick.

Hi John,
Comment for the Bitsa Blog...

I don't know if there is enough room or not on an 88"

I do. There is enough room under an 88" to drop the t/box and 4WD selector case off the gearbox in a single lump. I did this when I installed my Ashcroft t/box conversion.

Cheers,

Nick